7
2.4GHz 2 Channel remote system
Model: SR2S
9. 2.4GHz Operation notes
It use digital transmission mode, and this prevent outside interference effective
active and passive.
9.01 Matching (code)
Our products are well matched in the factory, you don´t need to match by yourself. If you
are going to match the receiver with another transmitter or you have to connect a new
receiver or transmitter, please follow the following steps:
1. Install the battery to the 2.4GHz transmitter and shut it down.
2. Insert the matching lines to the channel „BIND/VCC“ port of the receiver.
3. Switch on the ESC or connect a receiver battery to channel 3, at the same time the red
LED is flashing and this means the receiver is in the BIND mode.
4. Press and hold the „BIND“ button on the transmitter and switch on the power supply.
5. Observe the LED on the receiver. If the LED stops flashing, the binding process was
successful.
6. Release the „BIND“ button on the transmitter and take out the matching line.
7. Install the servo for testing
8. If the test fails, please repeat the action above.
BIND button
9.02 Switch on
1. Connect every servo.
2. Switch on the transmitter.
3. Switch on the ESC or power supply.
4. Receiver LED light solid.
5. Finish and use.
