Absima 2000010, Manual

Page: 37 / 42

4.4 Stick Calibration
This function is used to set the neutral position for throttle and wheel.
Every transmitter is calibrated before leaving the factory, however if recalibration is required,
please follow these steps:
1. Turn and hold the wheel as far clockwise as it will turn, hold the throttle all the way for ward,
then turn on the transmitter in calibration mode.
•
2. Calibrate wheel: Turn the wheel completely clockwise, then completely counterclockwise.
•
3. Trigger calibration: Pull the trigger back then for ward as far as it will go.
•
4. Once calibration is complete press the bind key to save and exit .
Danger
•
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Toggle the transmitter's power switch to the off position.
The R.LED and G.LED will flash twice.
When calibration is completed the R.LED will be off.
When calibration is completed the G.LED will be off.
Make sure to disconnect the receiver power before turning off the transmitter.
Failure to do so may lead to damage or serious injury.
4.5 Power Off