ABSCO SHEDS AWN33, Manual

Page: 9 / 45

Absco Industries Assembly Instruction Manual
ABSCO AWNING
MODEL: AWN33
3.00mW x 3.00mD x 3.00mH
Model: AWN33 15/11/19
9
Every connection should be fixed with two tek screws. Once
completed, carefully turn the frame over and fasten with tek
screws.
A. Secure the outside sections of the frame first with
one tek screw in each corner. Ensure that both diagonal
measurements are the same, then fasten each corner with
another tek screw.
B. Position each corner brace, fasten with two tek screws at
each end.
C. Move the remaining channel
sections into position. Do not
fasten any together until you
are satisfied they are all in their
proper position.
The end rafters will finish 8mm
short at each end to ensure a
tight fit over the front and rear
beams, and ensure that the
width of the frame will finish at
2850mm.
The ends of these rafters are not
pre-punched.
STEP 5. Frame Assembly
A
B
C
FRONT
BEAM
REAR BEAM
END RAFTE
R
EN
D R
AF
TE
R
. .
8mm
. . ..
. .
. .