Absco Industries
Assembly Instruction Manual
ABSCO EZISLIDER SHED
MODEL: 30082EK
3.00mW x 0.78mD x 1.80mH, 1.95mH
Model: 30082EK
22/11/18
1.1
14
DOOR PANEL ASSEMBLY
CHECK THAT THE HOLE CENTRE OF EACH DOOR HANDLE IS
32mm AS SHOWN. (SOME DOOR HANDLES MAY DIFFER)
MARK OUT THE HOLE CENTRES HALF WAY UP EACH DOOR. IT IS
IMPORTANT TO USE A GREAT DEAL OF ACCURACY WHEN
MARKING AND DRILLING THESE HOLES.
ENSURE THAT YOU MATCH THE DOORS UP AS A PAIR WHEN
FITTING THE HANDLES.
CAREFULLY DRILL 4mm OR 5/32" HOLES THROUGH BOTH SIDES
OF THE CHANNEL AND SHEET AS SHOWN.
FIT THE DOOR HANDLES USING THE 25mm BOLTS SUPPLIED.
A NORMAL PADLOCK CAN BE
INSERTED THROUGH BOTH
DOOR HANDLES FOR ADDED
SECURITY IF DESIRED.
THE BRUSH PILE STRIP IS USED TO REDUCE NOISE
WHEN SLIDING THE DOORS.
CUT THE ROLL OF BRUSH PILE SUPPLIED INTO FOUR
PIECES ABOUT 750mm LONG.
THE SELF ADHESIVE STRIPS ARE TO BE BONDED TO
THE TOP OF THE DOORS ONLY, ON BOTH SIDES
AS SHOWN.
ENSURE THAT SURFACES TO BE ADHERED TO ARE
CLEAN AND DRY.
PEEL OFF THE BACKING TAPE AND PRESS FIRMLY IN
POSITION FOR A PERMANENT BOND.
PART
262
32mm
4/4mm X 25mm
BOLT
FIT BRUSH PILE:
PART 263
BRUSH PILE
POSITION THE STRIPS TO THE
VERY TOP EDGE OF THE DOOR.
