55
54
STEP 11
FOLDING AIRBAGS
a
Attention! Improper folding will result in
poor opening of the airbags. This can lead to
malfunction and damage to the backpack!
a
Therefore, please fold the airbags according to
the following instructions.
1. Lie the airbags down with the suction and release
valve facing up. Fold the airbags to be the same
length as the base unit.
2. Starting from the top, fold the airbags to the op-
posite side of the suction and release valve.
4. The airbags are stored in their appropriate
pouches. The zippers must be at the upper and
lower end of the zipper before the airbags are
folded in. Once the airbags are in the pouch, pull
the zippers to the middle then pull back to the end
to close them. The Velcro can then be closed.
3. Fold the airbags towards the backpack ensuring
that each fold is approximately a hand’s width so
that the airbag can easily unfold. You can release
air continuously as you fold.
2
1
3
1
2
STEP 12
REPLACE CARTRIDGE AND ACTIVATION HANDLE
a
After every activation, the cartridge and the
activation handle must be replaced. Proceed
according to step 1, 2 and 4, 5. The ABS
®
-System
is then once again operational.
4.2 BEFORE EVERY TOUR OR USE
a
Follow steps 1– 6 of the Initial Operation:
1. Checking cartridge weigh
2. Attaching cartridge
3. Attaching straps and belts
4. Checking activation handle
5. Attaching activation handle
5. Velcro closure
4.3 AT THE END OF THE TOUR
a
Follow step 8 Removing activation handle of
the Initial Operation. The cartridge can remain
attached.
ENGLISH