4
Assembly:
1)
In order to assemble the module, you need the following tools:
*It is recommended to have some isopropyl alcohol and a fine soldering brush handy to clean off
the excess flux on the circuit board when the soldering is done.
*ATTENTION* DO NOT USE RUBBING ALCOHOL, IT WILL DAMAGE THE COMPONENTS.
2)
Open the package and verify the components. (refer to section 4. Bill of
Materials on page 3)
3)
Lay down all the components on your workbench and proceed to the next step.
4)
Prepare your soldering tools.
a)
Use an appropriate tip for the application. Also, make sure the
soldering tip is clean. Gently use a brass wool or a brush to clean the
tip when needed. Another way of cleaning the soldering tip is to use a
wet sponge.
