4
4.
Assembly:
1)
In order to assemble the module, you need the following tools:
*It is recommended to have some isopropyl alcohol and a fine soldering brush handy
to clean off the excess flux on the circuit board when done soldering.
*ATTENTION* DO NOT USE RUBBING ALCOHOL, IT WILL DAMAGE THE COMPONENTS.
2)
Open the package and verify the components. (refer to section
3. Bill of Materials on page
3 and 4 for this step)
3)
Lay down all the components on your workbench and proceed to the next step.
4)
*OPTIONAL* It is best practice to check component values using proper equipment (i.e.
using a Digital Multimeter to verify the ohmic value of the resistor) before proceeding to
the next step. You can also verify that the LEDs are working using the diode function of
your Digital Multimeter before soldering it onto the board.
