ABOVE&BEYOND PAGK44R, Manual

Page: 9 / 54

EN
5. Lay the roof canvas over the frame. Pull the nylon loops over
the corners as indicated in figure 4. On one of the corners
there is a drawstring to make it easier to pull the last loop
over the corner.
6. Place the pole so that the roof canvas is placed under
tension. Slide the peak of the roof over the top of the pole
and slide the pole base over the uppermost cross cable into
the centre. Affix the pole with the attachment clamp at the
bottom.
7. Attach the loops around the roof frame to the inside of
the sloping sides of the roof canvas. This gives the roof
structure extra support.
8. Place two poles on one side beneath the frame so that the roof frame lies at an angle (see figure 7a). Ensure that the widening
of the keder groove is at the top of the vertical poles and that the keder grooves are fitted at an angle of 45° in relation to the
corners of the tent (figure 7b).
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7A
FIGURE 7B
9. Place the two other poles in the same way and fit a base plate beneath each pole. Ensure that the openings in the base plate
correspond to the openings at the bottom of the pole, so that you can affix the poles in the base plates.