Parts and Contents:
Key
Description
Qty
A
Mixertap
1
B
Rubber seals
2
C
Cold and hot water inlets
(with integral check valves)
2
D
Base plinths
2
E
Upper sink seals
2
F
Lower sink seals
2
G
Fixing nuts
2
Installation Instructions:
Preparation
Before installing the new product it is essential that you thoroughly flush through the supply pipes in order to remove any
remaining solder, swarf or impurities from your system
. Failure to carry out this simple procedure could cause problems or
damage to the workings of the product or reduce performance invalidating the warranty.
We strongly recommend best practice of installing particle filters and isolation valves to both the hot and cold feed pipes in an
accessible position. This will help to prevent premature failure of the valves and ease any future maintenance.
All parts should be removed from their packaging and inspected for any transport damage prior to installation.
Shut off (isolate) your hot and cold water supply locally at the point of installation before continuing with the installation. If the
water cannot be isolated locally the turn off the mains stopcock and power to any heating system, now open the lowest tap or
drain point in the system until both hot and cold supplies are fully drained.
This product requires a 35mm
tap hole, if replacing an existing product, remove it and clean the end of the hot and cold feed
pipes using wire wool, the tap hole area should be free from dirt and sealant.
If the handles on the product operate backwards and forwards, allow for this when planning the sink or tap hole position.
Loosely position the product and fittings to check if any alteration to the existing pipework is required, if needed, do this now.
If the product is single flow (see section important technical data “flow characteristics”) then non return (check) valves must be
installed to comply with regulations. Some products are supplied with non-return valves this will be noted in the instructions.
⚠
Correct use of Flexible Hose Connectors
If this product is supplied with flexible hose connections for ease of installation you must observe the conditions below,
failure to observe these standard installation guidelines will invalidate the warranty for your product.
Always
screw
the flexi hoses
into the
product only
by hand,
until
feeling
mechanical
rest,
a spanner
must not be
used on the
product end of
the connecting
hose.
Always use the
pipes provided
and not an
alternative
substitute
The braiding
on the flexible
hose
must not
be in contact
with anything
else, for
example
chemicals,
internal or
external room
walls or
dissimilar
metals or
materials or
sharp objects.
Never twist or
stretch the
flexible hose
during
installation.
Do not
overtighten
the
hexagonal end
of the hose
connecting to
the supply
feeds when
using a spanner
causing the
hose to twist.
Hoses must
not be double
bent
in
multiple
directions
kinked or
looped
.
Observe the
minimum
bend radius of
50mm.
Before
assembling
the
hose to the
product
ensure
the hose
ferrule has
been crimped
(as highlighted)
on both ends of
the hose after
the braided
hose sleeve.
Both ends
of
the hose must
have a
minimum
50mm
straight
section
before
any bend.
50mmØ