ABM International, Inc. Series: 1018, 1022 & 1026 V5.0
Model: Innova Longarm Quilting Machine Service Guide
Proprietary information of ABM INTERNATIONAL, Inc. furnished for customer use only.
No other uses are authorized without the prior written permission of
ABM INTERNATIONAL, INC.
16
8. Using a pencil place a reference mark on the motor drive pulley.
9. Loosen the 4 screws on the motor mount and move the motor to the lowest position.
10. Hold the motor pulley so that the mark stays in the same position. Turn the sewing head drive shaft
counter-clockwise (facing the machine from the rear) and jump the belt on the motor pulley until the
needle is at its highest point and the take up lever is approximately ¾ of an inch from the top of the slot.
NOTE: THE TAKEUP LEVER SHOULD STILL BE TRAVELING UPWARDS IF THE SHAFT WERE
TURNED COUNTER-CLOCWISE.
11. Do not let the motor pulley turn while raising the motor to
tighten the belt. Tighten the (4) motor screws.
12. Run machine to check the up and down needle stop positions.
13. Repeat steps 9 thru 12 until you obtain the desired positions.
14. Replace the rear cover and motor cover.
