ABLE BA688CF-P, Installation & Maintenance Instructions Manual

Page: 8 / 19

6
4. INSTALLATION
4.1 Location
The BA688CF-P PROFIBUS display is housed in a
robust aluminium enclosure with a toughened
glass window mounted in a Noryl bezel. The front
of the instrument provides IP66 protection and a
gasket seals the joint between the instrument
enclosure and the panel. The instrument may be
installed in any panel providing the environmental
limits shown in the specification are not exceeded.
Fig 4 shows the overall dimensions of the
BA688CF-P and the panel cut-out. To achieve an
IP66 seal between the instrument enclosure and
the panel, the smaller cut-out must be used and
the instrument secured with four panel mounting
clips.
The BA688CF-P liquid crystal display has
maximum contrast when viewed from directly
ahead and slightly below the centre line of the
instrument.
Fig 4 BA688CF-P dimensions
4.2 Installation Procedure
a. Insert the BA688CF-P into the instrument
panel cut-out from the front of the panel.
b. Fix panel mounting clips to opposite sides of
the instrument and tighten until the
instrument is secure. Four clips are required
to achieve an IP66 seal between the
instrument enclosure and the panel.
c. Connect the panel wiring to the rear terminal
block(s) as shown in Fig 5. To simplify
installation, the terminals are removable so
that panel wiring can be completed before
the instrument is installed.
Fig 5 Installation and terminal connections