Ap1300 User Guide Page 14 of 16
10 WALL AND BELT MOUNTING INSTRUCTIONS
A combined bracket/clip suitable for fixing the Ap1300 to a wall or belt is available (ASL Product Code
AP1300BR-01). The bracket is included in the evaluation kits, and is supplied complete with wall
plugs and screws.
The bracket snaps into the bottom of the printer, and when used to clip to a belt, it may be secured by
using the supplied extended screw. Prior to use, two small 'break-outs' must be removed from the
battery cover of the Ap1300 as shown below:
Remove the two 'break-outs'
using a small screwdriver.
When fitting to a belt, the bracket should be slotted onto the printer first, and then the entire assembly
clipped over the belt as shown:
The securing screw may be fitted if required.
When fitting to a wall, the bracket must be located on the wall using screws and wall plugs as shown.
The printer may then be clipped into place and removed as required.
Use a finger or small screwdriver
to release the clip and then
gently lift the printer to remove
from the wall bracket.
