ABK i-Cooking, Installation Manual

Page: 9 / 12

EN 8 Installation instruction
Make sure that the underside of the 2.2 Place the housing of the cooktop under
worktop, where the cooktop will be fitted, the worktop and fit it with the 3 or 4 outer
is completely even and free from, dust, [temporarily] clamps/bolts, still loosened,
grease and glue remains. to the worktop.
Attention! The evenness is essential for
the cooling of the worktop by the
aluminum plate, which is fitted to the
worktop
2.1 First, the height of the adjustable edge
must be adjusted by yourself. Measure
the exact thickness of the worktop.
Use the mm indicators on the edge, to
make sure the thicknesses are exactly the
same on each position. Tighten the
screws firmly.
[The height of the edge and the worktop
will be 96mm].
2.3 Position the cooktop in such a position
that the burners and gas taps for the knobs
are in the centre of the cut outs.
2 Installation
!
EN 9 Installation instruction
2.4 Position and then fix the under-rings burners to the aluminum plate.
for the knobs, by screwing the M4 bolts Attention! Also remove the
into the aluminium plate. Depending on temporarily fixing clamps now.
the worktop thickness, the bolt can be tip: The clamps must be positioned over
shortened slightly, to prevent the bolt the worktop, as close to the edge of the
from getting in contact with the gas tap cut out as possible. If these are attached
components. Check and repeat this for to far/high over the edge, the burner-
each gas tap. fastening disk cannot be positioned
correctly and fixed 100% even anymore.
2.5 Place the steel eccenter disk over example Wok burner
the gas tap (extensions) to support the
gas tap and screw it firmly to the
worktop. Attention! Always use two
diagonally placed positions.
example Standard burner
2.7 Position the burner-fastening disk
above the burner house. If the plastic O-
ring [glued to the underside of the disk]
stands on the clamps, reposition the
2.6 Fix the remaining burner clamps. clamp. In case of the wok burner, the
Make sure all clamps are tightened bulb in the disk fits over the gas tube.
firmly to enable a maximum warmth Attention! For power, standard and
radiation from the worktop with the simmer burner, also use the fill rings>