Precomp
This item displays the number of cylinders at which to change the write timing.
Landing Zone
This item displays the number of cylinders specified as the landing zone for the read/write
heads.
Sector
This item configures the number of sectors per track.
Back to Standard CMOS Features Setup Menu:
Drive A
This item sets the type of floppy drives (usually only Drive A) installed.
Floppy 3 Mode Support
This item allows you to use “3 Mode Floppy Drive” in Japanese computer system by selecting
drive A, B, or both. Leave this item at its default [Disabled] setting if you are not using this
Japanese standard floppy drive.
Halt On
This item determines whether the system stops if an error is detected during system boot-up.
[All Errors]:
The system-boot will stop whenever the BIOS detect a non-fatal error.
[No Errors]:
The system-boot will not stop for any error detected.
[All, But Keyboard]:
The system-boot will stop for all errors except a keyboard error.
[All, But Diskette]:
The system-boot will stop for all errors except a diskette error.
[All, But Disk/Key]:
The system-boot will stop for all errors except a diskette or keyboard
error.
Base Memory
This item displays the amount of base memory installed in the system. The value of the base
memory is typically 640K for system with 640K or more memory size installed on the
motherboard.
Extended Memory
This item displays the amount of extended memory detected during system boot-up.
Total Memory
This item displays the total memory available in the system.
3-6
KN9 SLI, KN9 Ultra, KN9S
Summary of Contents for KN9 SLI
