Abilia 402500, User Manual

Page: 23 / 56

23
Press and release the button
X
on Big Jack on which the IR channel is to be placed. The red and
green indicator lamp now lights with a steady light.
Press and hold down the button
Y
on the remote control unit that is to be taught to Big Jack.
Release it when the red indicator lamp goes out. This may take as long as 10 seconds. If the red
indicator lamp returns to a red light, press again one or several times until both red and green
indicator lamps go out.
If the indicator lamp flashes red and a sound signal is heard , the teaching process has
failed. Repeat the process from step 4.
Conclude the process by pressing button
6
.
If the teaching process has succeeded for the first button, continue with the next button as
described above in points 3-6 until all IR channels are programmed.
TIPS: Big Jack can learn IR channels from most remote control units on the market, but there
are a few exceptions. It may affect certain functions or it may affect all of the functions on a
remote control unit. It is possible in these cases to use another teaching mode. Replace step 3
above by the following procedure: press in
P
and
1
at the same time and hold them
depressed for about 2 seconds until the green indicator lamp flashes and then goes out. The
unit is now in a different learning mode. Continue with the procedure described above.
Recording IR channels
P
+
1
, select button on Big Jack
X
, select button on standard remote
control
Y
, then continue or finish with
6
.