Abicor Binzel xFUME FLEX, Operating Instructions Manual, Page: 37 / 92

xFUME FLEX 8 Decommissioning
BAL.0733.0 • 2021-01-11
EN - 15
7.1 Control elements
1 Adjust the extraction arm (1) to accommodate the work task.
2 Adjust the extraction hood (6) to accommodate the work task. The extraction hood must be located approx. 20 cm above
the welding point during operation.
3 Establish an electrical connection.
4 Switch on the LED light (7) on the extraction hood (6) .
5 Adjust air volume to the work task.
6 Use the On/Off switch (4) to switch on the welding fume extraction system.
8 Decommissioning

Fig. 5 Control elements on page EN-15
1 Use the On/Off switch (4) to switch off the welding fume extraction system.
2 Disconnect the welding fume extraction system from the power supply.
1 Extraction arm
2 Handle
3 Service door
4 Device On/Off
5 4 castors
6 Extraction hood
7 LED light
8 Light switch
Fig. 5
Control elements
8
6
2
3
4
7
5
1