EN - 12
BAL.0414.0 • 2018-08-01
5 Handle operating elements
MB EVO PRO/MB EVO
5 Handle operating elements
The trigger’s two-cycle mode can be activated when using a standard welding torch. Further
operating modes and handle modules depend on the welding power source and must be
ordered separately.
5.1 Two-cycle trigger function
1
Press and hold the trigger on the handle = start welding.
2
Release the trigger = stop welding.
6 Operation
1
Open the shielding gas cylinder and switch on the power source.
2
Set the welding parameters.
3
Start welding.
7 Putting out of operation
1
Stop welding.
2
Wait until the shielding gas post-flow time has passed and then switch off the power source.
3
Close the valve on the shielding gas cylinder.
NOTICE
• Please make sure that the shutdown procedures for all components mounted in the
welding system are strictly observed before putting out of operation begins.
Fig. 10
Two-cycle trigger function
Start welding
Stop welding
NOTICE
• As liquid-cooled cable assemblies start to leak when they overheat, the cooling unit
should continue running for approx. 5 min. after welding.
