iROB Feed HA
6 Commissioning
BAL.0737.0 • 2019-11-15
EN - 13
The wire feeder is built as follows:
1
Unlock the latch
and open the right side of the housing.
2
Lift up the cover
.
3
Unscrew the knurled nut
from the spool mandrel.
4
Allow the drive pin to click into place.
5
Insert the spool.
6
Screw on the knurled nut
again.
7
Set the spool brake
8
Unlock the wire feeder's pressure rolls
9
Insert the end of the wire into the socket for the wire guide
and guide it over the roll into the torch connector.
10
Lock the pressure rolls
. The wire must be situated in the indentation of the roll.
11
Press the button for the wire feed.
12
Set the gas flow rate to a value between 5 and 20 l/min.
1
Latch
2
Cover
3
Pressure rolls
4
Socket for the wire guide
5
Spool brake
6
Knurled nut
Fig. 5
Wire feeder
1
3
5
6
2
4