FEC
5 Functional description
BAL.0533.0 • 2019-11-15
EN - 9
5 Functional description
Fig. 2 Functional description on page EN-9
The FEC is equipped with an extraction system
. Due to the vacuum created by the extraction system, air is sucked in
through the hose connected to the inlet
. A permanent filter
in the filter housing
eliminates the dust from the air that
is drawn in. The cleaned air is then returned to the room via an air exhaust louver.
When dedusting the filter cartridge
, the particles are collected in the filter housing
and can be emptied into a dust
collecting bag and then disposed of.
The fume extraction system is equipped with an automatic starting function, which means the system can start automatically.
For this function, a ground cable is laid in the integrated automatic Start-Stop system
. The automatic starting function is
switched on and off on the control panel.
6.2.2 Automatic starting functions on page EN-13
DANGER
Risk of fire
Before installing and operating the fume extraction system, please observe the following:
• The extraction of welding fume during welding of oil-wetted parts is not allowed.
• It is not allowed to install or operate the system in areas subject to dust or gas explosion hazards.
• Before commissioning, it must be checked if the operating voltage given on the nameplate corresponds to the
mains voltage.
• Observe the operating, maintenance and servicing conditions.
NOTICE
• The FEC fume extraction system may be used only in environments with sufficient ventilation.
• The fume extraction system is equipped with a control device (filter display, control panel on the right) for monitoring
the minimum volume flow.
5.1 Control elements on page EN-10
1
Filter housing
2
Inlet
3
Compressed air connection for
dedusting
4
Housing
5
Latch
6
Integrated automatic Start-Stop
system
7
Filter cartridge (permanent filter)
8
Extraction system
9
Air vent for dedusting
Fig. 2
Functional description
1
2
3
4
5
6
7
8
9
