EN - 22
BAL.0388.0 • 2018-08-08
11 Disassembly
e
BOX
11 Disassembly
1
Disconnect the cable assembly from the wire feeder.
2
Disconnect the connection leads from the
eBOX
.
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctly
dispose of the product, it must first be disassembled.
Please note the following information:
12.1 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents may not contaminate the ground or enter the sewage system. These substances must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables’ manufacturer.
12.3 Packaging
ABICOR BINZEL
has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Close off the gas supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
NOTICE
• Disassembly may be carried out only by qualified personnel (in Germany see TRBS 1203).
• Observe also the operating instructions of the welding components, such as the
welding components,
welding torch
system, re-circulating cooling unit etc.
• Observe the information provided in the following section:
