EN - 14
BAL.0173 • 2018-09-28
10 Troubleshooting
ABICUT 25K/45/75
4
Check the safety shut-off mechanism’s contact pins to ensure that their spring function is
working properly. If required, clean the protective cap’s contact ring to ensure a reliable
contact. Replace if necessary.
ABICOR BINZEL
offers factory repair services.
10 Troubleshooting
Please observe the attached ‘Warranty’ document. In the event of any doubts and/or problems,
please contact your retailer or the manufacturer.
DANGER
Risk of injury and device damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorised persons.
• Operating, maintenance, cleaning and repair work must only be carried out by qualified
personnel (in Germany, see TRBS 1203).
NOTICE
• Please also consult the operating instructions for the welding components, such as
welding torch, robot control, etc.
Fault
Cause
Troubleshooting
Insufficient penetration
• Pressure drop during cutting
• Reset the pressure monitor
• Cutting rate too high
• Reduce the cutting rate
• Tilt angle of the torch too great
• Reduce the tilt angle
• Material thickness too high
• Use a lower material thickness
• Equipment parts worn or
damaged
• Replace the equipment parts
• Output not adjusted
• Adjust the output
Cutting arc breaks
• Cutting rate too low
• Increase the cutting rate
• Torch clearance too great
• Reduce the torch clearance
• Material thickness too high
• Use a lower material thickness
• Output too low
• Adjust the output
Tab. 8
Troubleshooting
