ABICAR ADVANCED 42V
7 Operation
EN
-
19
7 Operation
► Consult the documentation for the welding components.
7.1 Functional check
► Switch the device on using the on/off switch.
WARNING
Risk of injury due to the device falling
At the end of workpieces, during operation on inclined or vertical surfaces, or in the event of high
external temperatures, the device may fall and cause serious injuries.
► Never leave the device to operate unattended.
► Secure the device with an anti-fall guard (e.g. fall arrester) to prevent it from falling. Use the securing
lugs for the anti-fall guard and observe the total weight inclusive of the attached parts (accessories,
torch, cable assembly).
► By actuating the travel direction switch, stop the device in the boundary area in good time before the
end of the workpiece.
► Only use the device on inclined or vertical surfaces together with the optionally available guide rail
system supplied for this purpose.
► High external temperatures may affect the stability of the magnet. Observe the maximum ambient
temperature for operation.
NOTICE
Material damage due to weather conditions
Weather conditions can cause irreparable damage to the device.
► Do not use the device in frost or rain.
Correct indicator after switching on. The
current speed will be displayed.
Indicator does not light up completely
► Consult your specialist dealer or the
manufacturer.
Indicator setting cm/min
6.5 Changing the speed indicators
(optional) on page EN
Indicator inch/min
6.5 Changing the speed indicators
(optional) on page EN
Travel direction switch not set to “O” when
the power supply is switched on
► Set the travel direction switch to “O” and
restart. Consult your specialist dealer or
the manufacturer if necessary.
Motor overloading. Device stops.
Possible reasons:
Use of unapproved electric cable.
► Use the electric cable as specified in the
technical data.
Obstacles blocking the welding car.
► Remove obstacles.
Consult your specialist dealer or the
manufacturer if necessary.
