ABICAR ADVANCED 42V
6 Putting into operation
EN
-
17
6.5 Changing the speed indicators (optional)
To change the speed indicators from cm/min to inch/min, and vice versa, perform the following:
1
Loosen the mounting screws in order to access the rear of the operating panel.
Fig. 3 Operating panel on page EN
2
Set the jumper
3
Re-secure the operating panel with the screws.
6.6 Connecting the power supply/power source communication connection cable
The connection cable is not included in the scope of delivery.
► Insert the power supply/power source communication connection cable into the bushing.
6.7 Switching on/off the device
► To switch on the device, depress the on/off switch until it engages.
After the device has been switched on, first the current software version number will be shown on the
display. The main menu will then appear.
► To switch off the device, fully depress the on/off switch and then release it.
After approx. 6 s, the device will switch off and the display and the LED in the on/off switch will disappear.
DANGER
Electric shock from electronic components
Improper work on electronic components may result in potentially fatal electric shock.
► Only have the speed indicator changed by a qualified electrician.
► Switch off the device.
► Disconnect all electrical connections.
Fig. 9
Rear of operating panel
A
Jumper
A
WARNING
Electric shock caused by damaged or improperly installed cables
The use of damaged or improperly installed cables may result in a potentially fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed, or worn parts replaced by a qualified electrician only.
WARNING
Risk of injury due to fire
A fire may occur due to improper use or connection. This may result in serious burns.
► Ensure that the operating voltage specified on the nameplate corresponds to the connection voltage.
