ABICAR 1200 PRO
6 Putting into operation
EN
-
13
* Accessories
► Mount guide arms to suit your requirements with the knurled screws left and right on the device.
6.2 Positioning guide arms
In order to ensure restricted guidance along the contact surface, the rear guide arm
must be adjusted so
that it is shorter than the front guide arm
. The adjustment depends on the direction of movement and the
length of the guide arm. The difference should be approx. 10 mm for a straight contact surface.
1
Loosen the knurled screws
and advance by 10 mm or one groove.
2
.
6.3 Connecting the weld start signal cable
The device can be operated with two welding torches.
Adjustment of the guide arm for external edges.*
► Adjust the height of the roller using the nuts.
Fig. 6
Adjustment of restricted guidance
A
Component
B
Guide arm, front
C
Knurled screws
D
Angle of approach
E
Guide arm, rear
Contact surface of the component
Travel direction
A
B
C
D
C
E
WARNUNG
Electric shock caused by incorrectly installed and damaged cables
Use of damaged or improperly installed cables may result in a potentially fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed or worn parts replaced only by a qualified electrician.
WARNUNG
Risk of injury due to fire
A fire may occur due to improper use or connection. They could cause major burns.
► Ensure that the operating voltage specified on the nameplate corresponds to the connection voltage.
