ABI-CAR E-1200 / E-1200-O
BAL.0647.0 • 2018-08-24
EN - 29
11 Disassembly
1
Disconnect all cables (power cable and possibly wire feed cable) from the welding tractor.
2
Remove the welding torch neck.
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctly
dispose of the product, it must first be disassembled.
12.1 Materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
You can obtain information about disposal and recycling of the aforementioned materials from the following (among others):
German Association for the Waste Disposal, Water and Raw Materials Industry (BDE – Bundesverband der Deutschen
Entsorgungs-, Wasser- und Rohstoffwirtschaft e.V.)
Behrenstrasse 29 / 10117 Berlin Germany / Tel.: 030 590 0335-0 / Fax.: 030 590 0335-99 / Email: [email protected]
12.2 Consumables
Oil, greases and cleaning agents may not contaminate the ground or enter the sewage system. These substances must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables’ manufacturer.
12.3 Packaging
ABICOR BINZEL
has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Switch off the control device.
• Switch off the entire welding system.
• Close off the gas supply.
• Disconnect all electrical connections.
NOTICE
• Disassembly may be carried out only by trained specialists.
• Please also consult the operating instructions for the welding components, such as the welding power source.
• Observe the information provided in the following section:
8 Decommissioning on page EN-26
NOTICE
• If the aforementioned material and machine parts are not taken for disposal directly, they should be stored properly. It
is essential to take precautions so that air, water, and the soil are not contaminated.
