60mm Diamond Hole Saw
SKU: 15206
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors that
are involved that can alter the installation method. This product
install must comply with AS/NZS 3500.
INSTALLATION GUIDE
How to cut your tile inser t
HOLE SAWS ARE INCLUDED WITH TAPS
Front View
Isometric View
65
19
60
57
10
37
Using the provided 60mm diamond hole
saw, drill incrementally deeper into your tile
until through.
Drill press:
we highly recommend getting a
professional to cut your tile using a drill press.
Work from the back face of the tile. Start
the drill on an angle so it is easier for the
hole saw to bite, then slowly bring the saw
vertical.
Hand drill:
we
do not
recommend using this
method unless you are highly experienced.
1
2
Front face
Back face
Vertical
72
8
72
15
62
8
52
Tile/Finished Wall Surface
Minimum distance between nogging and finished wall surface is 52mm
The maximum insert thickness will decrease to 8mm for this set back
(or 9mm from in-wall breech to finished wall surface).
Minimum distance between nogging and finished wall surface is 72mm
The maximum insert thickness will decrease to 8mm for this set back
(or 29mm from in-wall breech to finished wall surface).
Minimum distance between nogging and finished wall surface is 82mm
The maximum insert thickness will be at 15mm for this set back
(or 39mm from in-wall breech to finished wall surface).
standard spindle
Nogging
Breech
Maximum distance between nogging and finished wall surface is 62mm
The maximum insert thickness will be at 15mm for this set back
(or 19mm from in-wall breech to finished wall surface).
standard spindle
extended spindle
Back Plate
Handle Body
extended spindle
9
19
29
15
82
39
MINIMUM
MAXIMUM
MINIMUM
MAXIMUM
SET BACK GUIDE
Note: See set back table on next page for more details
INSTALLATION GUIDE
Note: This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors that
are involved that can alter the installation method. This product
install must comply with AS/NZS 3500.
