background image

SPECIFICATIONS

RECOMMENDED USE

CONSTRUCTION

Disclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards.  ABI and the manufacturer/distributor reserve the right to 
vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only.  The information listed is correct at the time of publication, however ABI and 

the manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2021. 

Note: 

Dimensions are nominal measurements only

INSTALLATION GUIDE 

Note: This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors that 
are involved that can alter the installation method. This product
install must comply with AS/NZS 3500.

IMP ORTANT: Spindle set backs are critical, refer to following pages for more details

PIXI TILE INSERT

ASSEMBLY HANDLE KIT

Domestic

Solid Brass

Front View

Top View

A-A

Back View

Note: 

Dimensions are nominal measurements only

A

A

10

10

65

50

6

44

13

1

53

Ø57 (max tile)

G1/2

8

6

M5x0.9x4

M5x0.9x4

20.

5

65

53

65

60

54

45

15

1

Screw backplate on to spindle & tighten firmly. 

2

Mount spindle attachment to spindle.* 

IMP ORTANT:

Ensure spindles are in the of f position, turn clockwise
to turn of f cold and anti-clockwise for hot  

3

Place cut tile on face of spindle attachment
and push both back and for th to align tile
face with the face of the handle. Tile face
should finish 43mm from face of base plate.
  

4

1.

 Remove tile from spindle attachment.

2.

 Fix spindle attachment into postion by inser ting

and tightening M5 grub screw using allen key 
provided. 

5

Put a small amount of silicone on the front perimeter
of the tile and push into handle and screw both on to 
base plate.  

How to orientate H/C sybmbol.

At this point note where the symbol is located when
the handle is in the of f position. Mark with a pencil
the position it needs to be. Return to step 2 and adjust
the base plates orientation by the referenced amount.
  

6

1.

 Screw handle on to spindle attachment, while

holding then tile in disired position.

2.

 Fix handle into postion by inser ting and

tightening the grub screw using allen key 
provided. 

1. 

2. 

IN THE B

O

X

2x Backplate

2x Spindle Att.

2x Handles

1x 5mm Allenkey

4x M5 Grub Screw

1x Diamond Hole Saw

43mm

1. 

2. 

SILIC

ONE

DO NOT use cream
cleaners or bleach.
These substances are
abrasive

Regularly clean with
mild liquid detergent
or soap and water

DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material

Reviews: