SPECIFICATIONS
RECOMMENDED USE
CONSTRUCTION
Disclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards. ABI and the manufacturer/distributor reserve the right to
vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. The information listed is correct at the time of publication, however ABI and
the manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2021.
Note:
Dimensions are nominal measurements only
INSTALLATION GUIDE
Note: This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors that are involved that can
alter the installation method. This product install must comply with AS/NZS 3500.
Domestic
Solid Brass
Note:
In wall not included in handle kit.
Note:
In wall not included in handle kit
Top View
Front View
Note:
Dimensions are nominal measurements only
78
25
54
14
26
13
35
74
New Build
-
Install breach in desired position (please refer to additional install information regarding breach set backs).
Retrofitting Existing
-
Remove existing tapware & reseat body seats until shiny and smooth.
DO NOT use cream
cleaners or bleach.
These substances are
abrasive
DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material
Regularly clean with
mild liquid detergent
or soap and water
Remove locking nut from spindle. Screw spindle into breach and hand
tighten until rear of spindle meets the body seat, be sure not to overtighten.
If necessary apply more pressure lightly with spanner.
Fit the fibre washer over the spindle. Screw on the locking nut and
tighten with spanner. TEST AND CHECK FOR LEAKS.
1
2
This product may require a bonnet extender (purchase at local hardware
store) that may be required to cover the additional breach depth. Please
refer to the following page for breach set back guide. If required, screw
bonnet extender on to locking nut.
3
Install the back plate onto the locking nut (or bonnet extender if
required), twisting by hand until tightened.
4
A 10mm brass spacer is provided to achieve optimum handle spacing
from the back plate. Insert spacer into rear side of handle and install
handle onto spindle, fixing with a screw and washer.
5
Insert handle cap into front of handle.
6
Note:
Bonnet extender
not included with assembly taps.
Available at local hardware store.
KINGSLEY ASSEMBLY HANDLE KIT
