DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material.
INSTALLATION GUIDE
Note: This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with AS/NZS 3500.
ELYSIAN BASIN MIXER
ø35mm
MAX35mm
MIXER OPERATION
Hot water hose
Cold water hose
Plastic washer
Metal washer
Nut
Screw
Mark hole in benchtop at desired
positon and drill a 35mm hole.
Installation should comply with relevant local
authority requirements.
This product must be installed by a qualified plumber.
INSTALLATION MANUAL
OFF
H
C
ON
COLD
HOT
As shown in the figure, connect the H & C
flexible hoses. ABI recommends applying
approriate lubricant to o-rings
Install the basin mixer by fixing
the washers, nut & screws on
the underside of the benchtop.
Attach the two flexible hoses to
water supply and hand tighten.
Remove the aerator from the
spout and flush. Re-install
aerator
Hot water
Cold water
** If installing into a thicker benchtop - a longer threaded
rod is required to fix the Basin Mixer down.
