INSTALLATION GUIDE
Ø35mm
MAX 30mm
1
2
3
4
5
What’s in the Box
1 Spout
2 Rubber O-ring
3 Aerator
5 Grub screw
6 Body
7 Dress ring
8-9 Flexible hoses
10 Rubber shoe plate
12 Car tridge
11 Horse shoe plate
13 Locking nut
14 Dome
15 Grub screw
16 Handle
HOT
COLD
OFF
ON
25
°
90
°
Operation
4 Spout tip
Drill a 35mm hole in desired install location.
As shown in left figure, connect the
flexi hoses.
Attach the two flexible hoses to water
supply.
Fix the bolts to the bottom of the body,
hand tighten.
Put the mixer into the hole. Pass
the horseshoe plates through the
bolts, fasten the nuts and tighten.
Further tighten bolts with a
screwdriver.
4
2
1
3
6
7
10
11
12
13 14
15
16
8
G1/2
9
5
Regularly clean with mild
liquid detergent or soap
and water
DO NOT use cream
cleaners or bleach.
These substances are
abrasive
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material
Note:
This product must be installed by a licensed plumber. This is a general installation guide - there are many factors involved that can
alter the installation method.
AU/NZ:
For installations within Australia and New Zealand, this product must be installed in compliance with
AS/NZS 3500.
UK:
For installations in the United Kingdom this product must be installed in compliance with the Water Supply (Water
Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws. Other: For installations outside these countries, this product
must be installed in compliance with the standards in your respective country.
