INSTALLATION GUIDE
3
Mark out fixing points centre to centre, on a level floor,
ensuring grab rail placement meets
AS1428.1:2021 standards.
Refer to alternative install location instructions for opposite wall
installation.
1061
71
1612
4
Align fixing points with rail configuration, using a level, double
check fixing location. Drill pilot holes accordingly.
level
5
Secure fixing brackets at previously marked fixing location.
Ensure fixing is level & fixed into appropriate structural support.
Drill
Coach Screw
Washer
Fixing Bracket
O ring
Pilot hole
6
Slide grab rails onto brackets & fix with grub screw. Ensure
all fixings are tight and secure.
2
Fix grab rails to brackets using allen key provided.
Note:
do not tighten grub screws completely, this aids wall
mount install process.
1
1
2
3
4
5
6
1
For rough in, refer to Step 3 for wall structure set out.
Set out grab rail in numbered configuration as illustrated below.
(Numbered indication appears on previous page).
1061
551
Quick Tip:
If sliding the
grab rail onto the brackets is
challenging, it may help to
remove this grub screw
during installation to allow
more movement. Be sure to
reinstall the grub screw!
Note:
This product must be installed by a licensed tradesperson.
This product’s install must comply with AS1428.1:2021 for installation
within Australia.
This is a general installation guide - there are many
factors that are
involved that can alter the installation method.
ABI takes
no responsibility if your product is not fixed to adequate wall structure
.
524
43
Structure
Structure
Structure
760
DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material.
IMPORTANT
Loosen grub screws to
aid installation.
Tighten once installed.
Note:
Dimensions are nominal measurements only
IMPORTANT
Place assembled grab rail
against wall to aid
wall marking/check
before drilling.
