Note:
For handle kit installation guide please refer to their respective install guides. This can be found on our website.
1. Body
2. Fixing Screws
3. Cartridge
4. Locking nut
IN THE BOX (IN-WALL)
2
Attach water supply and water outlet.
TEST AND CHECK FOR LEAKS.
3
DO NOT WATERPROOF SLEEVE.
Please ensure that the hole is big enough to allow
for the sleeve to slide on at fit-off stage.
1
Fasten screws to secure the wall
mixer into wall structure.
Note for Aliro Handle Kit Install:
Ensure setback is compliant with
AS1428.1:2021
ROUGH IN
1
2
3
4
INSTALLATION GUIDE
Note:
This product must be installed by a licensed plumber. This is a general installation guide - there are many factors involved that
can alter the installation method.
AU/NZ:
For installations within Australia and New Zealand, this product must be installed in
compliance with AS/NZS 3500.
UK:
For installations in the United Kingdom this product must be installed in compliance with the
Water Supply (Water Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws.
Other:
For installations outside
these countries, this product must be installed in compliance with the standards in your respective country.
Regularly clean with mild
liquid detergent or soap
and water
DO NOT use cream
cleaners or bleach.
These substances are
abrasive
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material
See Specification image for finish wall setback
ø
47mm
Sheeting and waterproof layer can
now be applied.
*Ensure cutout in finish wall is
47mm diameter.
