Please read fully and understand Setup Guide prior to operating the TR3!
ABI
(Absolute Innovations, Inc.)
-‐ 855-‐211-‐0598 -‐
www.abiattachments.com
Page
14
of
17
CHECKING THE PROFILE BLADE FOR LEVELNESS AND DEPTH:
Once the Profiler attachment is set up you will want to set the depth of the Profile Blades. Below are instructions
on setting the depth:
1.
Raise the TR3 off the ground until the wheels are lifted up to match (roughly) the depth desired to use the
profile blades at. If the desired grooming depth for the profile blades is about 2”, then raise the TR3 until
the wheels are roughly 2” off the surface. **As footing becomes loosened the TR3 may rest lower in the
footing.
2.
Remove the pins from each arm of the Profile Blade allowing it to rest on the ground. Do this for both
sides of the Profile blade(s)
3.
Insert the pins back into the Profile Blade arms to secure the Profile Blades. There are two holes in the
arms of the Profiler attachment Profile Blades. Choose the closes hole to where the desired depth of the
Profile blades is, and insert the pins.
Next, take the TR3 out into the Arena and being dragging the Arena with the TR3 and Profiler attachment.
Once the Scarifiers and Profile Blade(s) have entered the footing stop and check to make sure everything is at the
depth desired to drag the Arena at, and that the Profile Blade is setting level to base. To check the levelness and
depth of the Profile Blade, pull the footing back from the edge of one side of the Profile Blade. Continue to remove
the footing until the base can be seen under the Profile Blade. Ensure that the Profile Blade is setting level to the
base of the Arena and at the proper depth. If the Profile Blade is not sitting level, adjust the levelness using the 11”
Top Link used to secure the Profiler attachment to the TR3. Continue dragging a few more feet, and recheck the
profile blade again. You may need to make multiple adjustments to get the profile blade to sit level to the base. If
you need to adjust the depth up or down repeat the above steps to set the depth of the Profile Blade.
ADJUSTING THE FINISH RAKE ON THE PROFILER ATTACHMENT:
1.
To adjust the Finish rake on the Profiler attachment, raise or lower the Finish Rake depending on the
desired effect on the footing.
2.
There are 3 holes on the outside mast of the Profiler attachment where the Finish Rake is attached.
Remove the pins holding each arm of the Finish rake in place, and raise or lower the Finish Rake
depending on the effect desired for the footing. Put the Finish Rake in the top hole for the least contact
with the footing. Put the Finish Rake in the bottom hole for maximum contact with the footing.
