Visit:
www.abisupport.com
10
Setup (cont'd)
Fig 17.
4
. Line up the free end of the toplink with the loose bolt on
the mat bracket by holding the end of the toplink to keep
it from rotating while rotating the handle on the toplink
counterclockwise (to extend the toplink ends) (
Fig 21 and
22
). Once the hole in the toplink lines up with the bolt holes
in the mat bracket, slide bolt thru the toplink end and other
end of brackets. Replace washer, lockwasher and nut onto
bolt and tighen using (2) 15/16" wrenches or socket set (
Fig
22
).
5.
To remove the unit from the skid, crank the front jack
clockwise to lower the wheels as far as they will go. This may
cause the unit to start to roll off the skid (
Fig 23
). Next, crank
the rear jack counterclockwise to adjust the finish rake to be
horizontal so as not to drag on the skid when removing the
unit from the skid (
Fig 24
).
6
. Attach the Rascal to the tow vehicle and pull away from
the skid (
Fig 25
).
Fig 15.
Fig 13.
Add bolt to (1) hole then remove punch or 6"
long 3/8" ratchet extension to add 2nd bolt.
Make sure hitch
coupler lever and label
are facing the same
direction when hitch
bar is installed.
Hold tongue bar while
removing zipties to
avoid injury if tongue
bar falls foward.
Fig 14.
Fig 16.
Remove these
zipties at this
time.
