Installation Guide
A
B
C
540mm
D
D
E
F
G
I
H
WALL
K
K
J
L
L
M
N
4. Attach bottom rail
(J)
to top wall connector. No thread tape required. Slide the cover
plates
(K)
onto the top and bottom wall connector assemblies.
2. Loosen grub screws
(D)
and remove the threaded insert
(E)
by temporarily
attaching the male thread of the bottom rail
(J)
. Apply thread tape to male thread
of lugged elbow
(F)
(protruding from the wall). Screw bayonet fitting onto lugged
elbow.
5. Insert the rail onto the top bayonet fitting and bottom brass insert simultaneously.
Tighten grub screws
(L)
.
6. Fit top showerhead
(M)
ensuring that the seal and flow control are in the correct
position. And attach hose to bottom threaded outlet
(N)
and hand-shower to the
hose ensuring flow control is fitted correctly.
3. Remove brass insert
(G)
from bottom wall connector assembly by loosening grub
screw
(H)
. Position the brass insert on the wall. The centre should be 540mm below
the centre of the top wall connector. Mark screw positions on the wall. Drill 2 x φ6mm
holes and attach brass insert with raw-plugs
(I)
and screws provided.
1. The hand-shower holder can be located either above or below the top wall
connector
(A)
. It is supplied fitted above. To reposition the holder, you need to
loosen the grub screw
(B)
and remove the top arm from the wall connector.
Remove the holder
(C)
and reconnect the arm to the wall connector .
Note: The flow control should be inserted with the protruding side into the
showerhead, taking care not to cause and damage to the flow controller. In
accordance with AS/NZS3662 CI.6e. These showers may not be suitable for
use with gravity fed waterheaters, low and unequal pressure supply networks,
instantaneous water heaters, tempering valves and/or thermostatic mixing
valves. In accordance with AS/NZS3662CI.6c.
The following pressure range should be complied with:
·Minimum working pressure 150Kpa
·Maximum working pressure 750Kpa
ALL ABEY SHOWERS MUST BE INSTALLED IN ACCORDANCE WITH
AS/NZS3500 SERIES.
ALL ABEY SHOWERS ARE CERTIFIED IN ACCORDANCE WITH
AS/NZS 3662:2005, LICENCE NUMBER WM-022172.
