32
AirCleaner
•
User Guide
3. Updating Software & Firmware
Updating Software & Firmware
8. In the Command Prompt window on your Windows PC, type the following
command (followed by ENTER):
•
ping ipaddress
(where “
ipaddress
” is the IP Address of AirCleaner.
The factory default IP Address is “
192.20.200.240
”)
You should get four replies, similar to that shown below. If no reply is made
from AirCleaner, verify a standard Ethernet cable is connected to your LAN. If
that’s connected, then review and perhaps re-perform the procedure to set the
AirCleaner’s IP address, as detailed in the paragraph
above.
9. In the Command Prompt window, type the following command (followed by
ENTER):
•
ftp ipaddress
(where “
ipaddress
” is the IP Address of AirCleaner.
The factory default IP Address is “
192.20.200.240
”)
Within a few moments, AirCleaner will reply with a “
User
” login prompt, as
shown here by the lower arrow:
Summary of Contents for AirCleaner
