![background image](http://html1.mh-extra.com/html/abbott/vp-2000-processor/vp-2000-processor_service-manual_450983252.webp)
Repair, Replacement of Spare Parts
Section 7
7-60
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008
Removal
1. Remove the Hoods by gently squeezing inward on the two
(2) metal arms that connect the Hoods to the unit.
Remove the Carrier-Tray Assembly.
2. Remove the Top Cover by unscrewing six (6) 6-32 x 1/4
Phillips-Head screws, three (3) on each side of the unit.
3. Using an IC extraction tool, remove the PROM at (U6 on
the printed circuit board).
Installation
Reassembly by following the removal procedure in reverse.
CAUTION:
Before sliding the Top Cover back into
position, make sure all wiring, cables and connectors
are replaced snugly, within the unit and not hanging
out where they might be sheared off when replacing
the cover.
NOTE:
Consult service bulletins and/or packing slip
data to determine whether the replacement PROM is
the correct version. If the PROM being installed is a
new version with enhanced or special features, be sure
to notify and instruct the operator.
NOTE:
When replacing the PROM, ensure that it is
oriented properly.