Setup Guide: CONNECT Universal Gateway With ID NOW
TM
(Direct-Connect)
Abbott Rapid Diagnostics Informatics, Inc. (ARDx Informatics)
D10036883 REV AA
Page 16 of 26
February 1, 2021
© 2021 Abbott. All rights reserved.
All trademarks referenced are trademarks of either the Abbott group of companies, or their respective owners.
Any photographs displayed are for illustrative purposes only.
Configuration
In order for the
second
ID NOW
TM
instrument to communicate with the CONNECT Universal Gateway, additional
configuration steps are required, as follows:
Step Action
Illustration
1
VERIFY
that the
second
ID NOW
TM
device is powered
on.
TURN
ON
the CONNECT Universal Gateway.
Note: The CONNECT Universal Gateway will
automatically switch on once attached to power. If
this does not occur, press the Power button.
2
CHECK
the status lights on the CONNECT
Universal Gateway
Observe and check the three device status
lights
1, 2
and
3.
If a solid
Status 1
light does not appear within
two minutes, restart the CONNECT Universal
Gateway by pressing and holding down the
Power button for five seconds.
The
Status 2
light will flash while the device
attempts to connect.
The
Status 3
light will remain solid green
when a successful connection is established
with RALS LiNK
TM
or Sympheos
TM
.
3
POWER ON
the
second
ID NOW device.
Ssubsequent steps will be completed on the
second
ID NOW
TM
device.
Summary of Contents for CONNECT
Page 1: ......