5-84
CELL-DYN
3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
Using the Work List
Introduction
The Work List is used to preassign sample identification, display and
print criteria for samples that will be run. It is essentially a list of samples
(including the preassigned information) that the operator intends to run
on the instrument. A Work List can be downloaded from a host computer
to the CELL-DYN 3000. The use of the Work List is optional.
Detailed discussions of using the Work List with and without bar coded
samples are provided in this section. Instructions are also given for
handling STAT samples with and without bar code labels.
As the samples are processed, the Work List is accessed and the entered
information is displayed on the
stored in the Data Log. The information is also printed on the report. The
Work List may be used with or without bar code labels on the tubes.
CAUTION: If bar code labels are not used, samples must be
processed in the same order in which the information is listed on
the Work List.
The following bar code symbologies may be used:
•
Codabar, Interleaved 2 of 5 or Code 39
These bar code labels are generated by the user and are typically
used when the bar code number is the Sample ID number.
•
CELL-DYN 4-Digit Bar Code (Code 39)
These bar code labels are available for the Sample Loader and may
be used for sample identification when the bar code number is not
the same as the Sample ID number. This option must be selected in
the Work List Set Up.
NOTE: Refer to
information on the use of bar code labels.
Search
Go Back
Book TOC