Do not instal within 10 feet of a pool, spa or fountain
CAUTION:
fixture(s) must be installed in accordance with all local codes and ordinances.
INSTALLATION INSTRUCTION
www.ABBALightingUSA.com
To ensure optimal performance and safety, it is
important to use our fixtures ONLY with a low
voltage
landscape
transformer.
This
transformer reduces the voltage from 120V to
12V, making it safe and suitable for outdoor use.
When installing the fixture(s), please follow
these instructions carefully:
1.Before installation, please ensure that
the power is turned off for your safety.
2.Using a pencil or marker, carefully mark the
hole on your preferred location.
3.Create a hole on your marked location with a
diameter of 4.07 inches for accommodating a 4-
inch panel light
4.Position the drill on the marked spot and
gently drill a hole.
We recommend using
WN12
waterproof wire
nuts (sold separately) for optimal connectivity.
5.Strip
the
insulation:
Carefully
strip
approximately 3/4 inch (1.9 cm) of insulation
from the ends of the two wires you wish to
connect. Ensure that the bare metal ends are
clean and free from any frayed strands.
6. Align the wires: Hold the stripped ends of the
two wires together, aligning them neatly and
ensuring that no stray strands are crossing over
7. Insert the aligned ends of the wires into the
wire nut, ensuring that they go all the way in.
The bare ends should be completely covered by
the wire nut. Twist the wire nut: Firmly twist the
wire nut clockwise onto the wires, ensuring a
secure connection. Continue twisting until the
wire nut is tight and snug. It is recommended to
apply electrical tape around the wire nuts and
wires as an extra layer of protection.
8.Test the connection: Gently tug on each wire to
ensure they are securely held by the wire nut.
9.Remember to test the fixture after making any
adjustments to ensure it is functioning correctly
and that the lighting is set to your preferences.
You can set the light temperature you want to
3000K, 4000K & 5000K.
10.Adjust the fixture's clips by bending them as
necessary, then position the fixture over the hole
11. Once the fixture(s) have been installed
securely, it's time to turn on the power and enjoy
the enhanced lighting experience! Locate the
power switch or breaker that controls the
fixture(s) and turn it on. Take a moment to
observe the lighting effect
Remember to regularly maintain and clean the
fixture(s) to ensure optimal performance and
longevity.
Refer
to
the
manufacturer's
instructions for specific details on how to care for
your particular fixture.
