ABB W2153 BL, Quick Manual

Page: 5 / 16

Q U I C K G U I D E 5
Interface description
Audio module on the video aluminum outdoor station
No. Description
1 Connector for camera module
2 Connector for device software update
3 Plug-in clamps(COM-NC-NO) for floating output, door opener (30
V AC/DC 1 A)
4 Plug-in clamps(Lock-GND) for door opener (18 V 4A impulsive, 250
mA holding)
5 Plug-in clamps(DC-GND) for additional power supply
6 Plug-in clamps(a-b) for Bus connection
7 Connector for induction loop module
8 Connector for next module
9 Connector for exit pushbutton
10 Connector for sensor to check the door status
11 Rotary switch to set the address of OS (1-9)
12 Set feedback tone of push button: ON/OFF
13 Configure push button as single column or double columns
(ON= double columns; OFF= single column)
14 Configure function of 1st / 2nd push button
3->OFF, 4->OFF=call indoor station/call indoor station;
3->ON, 4->OFF=switch on lightings/call indoor station;
3->OFF, 4->ON=call guard unit / call indoor station;
3->ON, 4->ON=switch on lightings / call guard unit.
15 Adjust loudspeaker volume
16 Adjust door lock release time, 1-10 seconds
No. Description
1 X100 X10 X1
Jumper to set the address of the indoor station.
Example: setting address 024
2 Master /Slave function
Only one indoor station in each apartment must be set as “Master”
(Jumper should be set as ‘M/S on’). All additional indoor stations
in the same apartment must be set as “Slave” (Jumper should be
set as ‘M/S off’).
3 Terminal resistor
In video installations or mixed audio and video installations, the
Jumper must be set as ‘RC on’ on the last device of the line.
4 a b = Bus connection
5 a potential free contact, such as a doorbell pushbutton
1 2
3 4 5 6 7 8 9 10
11
12
13
14
15
16
024
1
2
4
3
Indoor station
hundreds digits
X100
0
5