20
TZIDC-200
DIGITAL POSITIONER | CI/TZIDC-200/C-FM-US-EN REV. B
… 5 Installation
… Mechanical mounting
Mounting on linear actuators
For mounting on a linear actuator in accordance with DIN /
IEC 60534 (lateral mounting as per NAMUR), the following
attachment kit is available.
1
Screw
2
Washer
3
Mounting bracket
4
Lever with follower pin (for travel
10 to 35 mm (0.39 to 1.38 in) or
20 to 100 mm (0.79 to 3.94 in)
5
Washers
6
Screws
7
U-bolt
8
Washers
9
Nuts
j
Screws
k
Spring washers
l
Clamp plates
m
Follower guide
Figure 5: Components of attachment kit
Figure 6: Attaching a follower guide to the actuator
1. Tighten the screws so that they are hand-tight.
2. Attach the follower guide
1
and clamp plates
2
with
screws
4
and spring washers
3
to the actuator stem.
Figure 7: Assemble lever (if not pre-assembled)
1. Insert spring
8
on bolt with follower pin
9
.
2. Slip the plastic washer
7
onto the bolt and compress the
spring with it.
3. Insert the bolt with compressed spring into the oblong hole
in the lever
6
and fasten it in the desired position using the
plain washer
5
and nut
4
at the lever. The scale on the
lever indicates the link point for the stroke range.
4. Place the washer
2
on the screw
1
. Insert the screw in the
lever and lock with the nut
3
.
