ABB Terra Mobile 44HV, Operation And Installation Manual, Page: 38 / 66

6 Operation
6.1 Prepare before use
Preliminary requirements
• Owner
Procedure
1. Make sure that:
• The EVSE is installed according to the instructions in this manual.
• The wheel brakes of the EVSE are locked.
• If the floor locks are present, the floor locks are locked.
2. Make an emergency plan that instructs people what to do in case of an
emergency.
3. Give these instructions to each end user:
• Emergency stop. Refer to section 6.2 .
• Charge session. Refer to section 6.5.1 .
4. Make sure that the manufacturer commissions the EVSE. Contact the
manufacturer when the EVSE is ready for commissioning. Refer to section 5.4 .
Danger:
General risk
• Make sure that you have approval of the manufacturer to use the
EVSE after commissioning. After approval, do not move the EVSE.
5. Make sure that the space around the EVSE cannot get blocked. Think of snow or
other objects. Refer to the floor space requirements. Refer to section 11.13.2 .
6. Make sure that maintenance is done on the EVSE. Refer to section 7.1 .
7. If the EVSE is de-energized for more than two hours, activate the internal heater
to remove condensation from the cabinet. Refer to section 7.2.1 .
Caution:
Remove condensation before use, to prevent damage to the EVSE.
6.2 Stop the EVSE if there is an emergency
1. If there is an emergency, push the
emergency stop button.
• The EVSE stops all charge sessions.
• The touchscreen shows a message.
2. Do not start the EVSE until the situation is safe.
Operation
38 9AKK108467A6997-EN | 003