ABB SPACOM 100, Operating Manual, Page: 3 / 12

R E L AY R ETROFIT PROG R A M CUT TI NG TOOL
O P ER AT I N G G U I D E SPACO M 10 0 3
—
1. Preparations
You can perform the cutting from the front
or the back of the door panel.
In this example cutting is done from the back,
because the supporting structure of the door is
close to the assembly opening.
Ensure that there is enough space to operate
the cutting tool in all intended directions.
Check the space required by the replacement
IED and its wiring.
Start by removing the existing relay.
1.1
1.2