Videographic Recorder
SM1000
4 Configuration
IM/SM1000
Issue 11
85
Set the 'Preset count' value – the value the totalizer counts from
and the value applied when the totalizer is reset.
Set the 'Predetermined count' value – the value at which the
totalizer stops or wraps.
Note.
A counter configured to count up must have a 'Preset
count' value lower than the 'Predetermined count' value. A
counter configured to count down must have a 'Preset count'
value greater than the 'Predetermined count' value.
Set the required number of decimal places on the higher of the
'Preset count' value or 'Predetermined count' value.
Set the 'Intermediate count' value – the value at which a digital
source is activated. This can be used as an alarm threshold to
indicate when the 'Predetermined count' value is about to be
reached.
Select a 'Reset source' signal (see Appendix A, page 104) – an
edge-triggered signal to reset the totalizer on a rising edge.
Select the frequency with which totalizer values are added to the
Totalizer log.
Select a 'Log update source' signal (see Appendix A, page 104)
– an edge-triggered signal to trigger the addition of the current
totalizer values to the Totalizer log on a rising edge.
Log update time
Log updated every...
5 minutes 0, 5, 10, 15... etc. minutes past the hour
10 minutes 0, 10, 20, 30,...etc. minutes past the hour
15 minutes 0, 15, 30, 45 minutes past the hour
20 minutes 0, 20, 40 minutes past the hour
30 minutes 0, 30 minutes past the hour
60 minutes On the hour
2 hours Midnight, 2am, 4am, etc.
3 hours Midnight, 3am, 6am, etc.
4 hours Midnight, 4am, 8am, etc.
8 hours Midnight, 8am, 4pm, etc.
12 hours Midnight, 12am
24 hours Midnight
