Isolated LAN 3 network
The default configuration is that LAN 3 is configured as an isolated network. This
allows several robot controllers to be connected to the same network.
WAN
LAN 2
LAN 3
Private
Robot Controller
LAN 1
Service
Public
Isolated
LAN 3
xx1500000393
By connecting to the isolated LAN 3 port it is possible to connect several robot
controllers to a dedicated industrial network.
WAN
Factory Network
LAN 2
LAN 3
Private
Robot Controller 1
LAN 1
Service
WAN
LAN 2
LAN 3
Robot Controller 2
LAN 1
Service
PLC
Sensor
Cell I/O
I/O
I/O
Industrial Network
Isolated
LAN 3
Public
Private
Isolated
LAN 3
Public
Camera
EtherNet/IP
xx1500000388
I/O signals setup
All necessary I/O signals are setup by the
Miller Auto-Axcess E Addin
.
Ethernet/IP communication setup
The steps to setup the Ethernet/IP communication are as follows.
1 Choose the robot controller Ethernet/IP IP address.
2 Choose the Miller Ethernet/IP IP address in a compatible range.
3 Setup the Miller Ethernet/IP IP address in the Miller Auto-Axcess. See section
Setup Miller Ethernet/IP address in Miller Auto-Axcess on page 29
.
Continues on next page
Application manual - Miller Ethernet I/P Interface and Weld Editor
27
3HAC054885-001 Revision: -
© Copyright 2015 ABB. All rights reserved.
2 Installation and setup
2.3.1 Overview
Continued
Summary of Contents for RobotWare 6.02
