ABB RELION Series, Product Manual

Page: 7 / 33

IEC04000452-3-en.vsd
1b
1a
2
3
IEC04000452 V3 EN-US
Figure 1. The rack mounting kit
Flush mounting for 670 and 650 series
IP652-1 v2 M1929-3 v2
Use the flush mount kit for installation in a panel cut-out.
M1938-3 v2
The flush mounting kit for release 2.1 and earlier consists of
four fasteners (2) with appropriate mounting details (4) and
a sealing strip (5) for fastening to the IED (3). See Figure
2 .
From release 2.2 onwards, the flush mounting kit consists of
two fasteners (2) with appropriate mounting details (4) and
a sealing strip (5) for fastening to the IED (3). See Figure
3 .
The two fasteners are pre-assembled to the box.
To receive IP54 class protection, an additional sealing (1)
must be ordered with the IED. This sealing is factory
mounted.
IEC04000451-2-en.vsd
IEC04000451 V2 EN-US
Figure 2. The flush mounting kit (release 2.1 and earlier)
1
5
6
3
IEC16000080=1=en.vsd
2
4
IEC16000080 V1 EN-US
Figure 3. The flush mounting kit (release 2.2 onwards)
Wall mounting for 670 and 650 series
IP651-1 v2 M1974-3 v1
Use the wall mounting kit to projection mount the IED on a
wall.
M1973-3 v1
The wall mounting kit consists of a mounting bar pair (4)
and a IED bracket pair (6). Screws (2) and (5) and washers
(1) for fastening of the terminal are included, but not wall
fasteners (3).
xx04000453.vs d
1
2
3
4
5
6
IEC04000453 V1 EN-US
Figure 4. The wall mounting kit
Wall mounting for SAM600-IO
GUID-2C7B44A9-6E63-4859-B20C-6EB36A9E0170 v1
Use the wall mounting kit to projection mount the SAM600-
IO on a wall, see figure
5 .
The wall mounting kit consists of 8 washers (1), 8 screws
(2), 2 mounting profiles (3), 6 nuts (4), 4 spacers (5) and 2
mounting angles (6).
To order wall mounting kit, refer to section Mounting
accessories .
670/650 series and SAM600-IO IEC 1MRK 514 012-BEN K
Hitachi Power Grids 7
© 2017 - 2021 Hitachi Power Grids. All rights reserved.