ABB RELION REF615R, Technical Manual

Page: 93 / 664

The
OUT
output indicates quality bad of the input signal. Input signals that have any other
than test bit set, will indicate quality bad status.
3.12.2.2 Signals
Table 48: QTY_BAD Input signals
Name Type Default Description
IN Any 0 Input signal
Table 49: QTY_BAD Output signals
Name Type Description
OUT BOOLEAN Output signal
3.12.3 T_HEALTH function block
3.12.3.1 Functionality
The T_HEALTH function evaluates enumerated data of “Health” data attribute. This
function block can only be used with GOOSE.
The IN input can be connected to GOOSERCV_ENUM function block, which is
receiving the LD0.LLN0.Health.stVal data attribute sent by another device.
The outputs
OK
,
WARNING
and
ALARM
are extracted from the enumerated input value.
Only one of the outputs can be active at a time. In case the GOOSERCV_ENUM function
block does not receive the value from the sending device or it is invalid, the default value
(0) is used and the
ALARM
is activated in the T_HEALTH function block.
3.12.3.2 Signals
Table 50: T_HEALTH Input signals
Name Type Default Description
IN1 Any 0 Input signal
Table 51: T_HEALTH Output signals
Name Type Description
OK BOOLEAN Output signal
WARNING BOOLEAN Output signal
ALARM BOOLEAN Output signal
1MRS240050-IB C
Section 3
Basic functions
REF615R 87
Technical Manual