ABB Relion 670 series, Technical Reference Manual

Page: 1157 / 1232

19.4.4.3 IED in the 670 series mounted with a RHGS6 case
An 1/2 x 19” or 3/4 x 19” size IED can be mounted with a RHGS (6 or 12 depending
on IED size) case. The RHGS case can be used for mounting a test switch of type
RTXP 24. It also has enough space for a terminal base of RX 2 type for mounting of,
for example, a DC-switch or two trip IEDs.
xx06000180.vsd
8 8 8
7
5
6
3
4
2
7
5
6
7
5
6
3
4
2
3
4
2
1
1
1
2
1 1
1
8
7
5
6
3
4
2
2
2
1
IEC06000180 V1 EN
Figure 561: IED in the 670 series (1/2 x 19”) mounted with a RHGS6 case
containing a test switch module equipped with only a test switch and a
RX2 terminal base
19.4.5 Side-by-side flush mounting
19.4.5.1 Overview
It is not recommended to flush mount side by side mounted cases if IP54 is required. If
your application demands side-by-side flush mounting, the side-by-side mounting
details kit and the 19” panel rack mounting kit must be used. The mounting kit has to
be ordered separately. The maximum size of the panel cut out is 19”.
With side-by-side flush mounting installation, only IP class 20 is
obtained. To reach IP class 54, it is recommended to mount the IEDs
separately. For cut out dimensions of separately mounted IEDs, see
section
"Flush mounting" .
1MRK505222-UUS C
Section 19
IED hardware
1151
Technical reference manual