ABB PST30, Installation And Commissioning Manual

Page: 18 / 200

Quickstart
Chapter 2
18
1SFC132003M0201
2:2 Configuration
1. Enter the Application Setting by pressing left selection key
twice. Press Select using the left selection key. Figure 4.
2. Select the appropriate type of load using navigation keys.
Figure 5.
3. Press Store Set and Nex t to continue or Back to previous
parameter using the selection keys. Figure 6.
4. Set the Setting Ie using the navigation keys.
In Line connected = rated motor current
inside Delta connected = 58% (
) of the rated
motor Icurrent. Figure 7.
5. Press Store and Next to continue or Back to previous
parameter using the selection keys. Figure 8.
6. Set the required overload class using the navigation keys.
Figure 9.
7. Press Store and Next to continue or Back to previous
parameter using the selection keys. Figure 10.
8. If an external by-pass contactor is used set Ext ByPass to
Yes using the navigation keys. (PST30...300 only).
Figure 11.
9. Press Store and Next to continue or Back to return to pre-
vious parameter using the selection keys. Figure 12.
10.Select Yes if ready or Tune Set if start/stop mode, ramp
types, initial/end voltage, current limits etc. needs to be
adjusted using selection keys. Figure 13.
11.To change presentation language, see section 7:2.5.
2:3 Start of the motor
1. Switch on the main voltage.
2. Give start command to the softstarter.
(To start the softstarter from the keypad, enter the LOCAL
CONTROL menu, select
Start/Stop, and press Start . The
motor must be stopped before leaving this menu.)
Application Setting
Select Back
Figure 4: Application setting menu
Centrifugal Pump
Store Set Back
Figure 5: Centrifugal pump
Centrifugal Pump
Next Back
Figure 6: Centrifugal pump stored 1 3
( ) ⁄
Setting Ie 99.0A
Store
Figure 7: Setting Ie
Setting Ie 99.0A
Next Back
Figure 8: Setting Ie stored
OL Class 10
Store
Figure 9: OL Class
OL Class 10
Next Back
Figure 10: OL class stored
Ext ByPass No
Store
Figure 11: External Bypass
Ext ByPass No
Next Back
Figure 12: External Bypass stored
Ready?
Yes
Tune Set
Figure 13: Ready / Tune Set